What Remote ID is and which drones must broadcast it

Remote ID is the signal a drone broadcasts in flight: the operator number, the drone's position and where the pilot is standing. See which drones in the EU must broadcast it.

Updated:

In short. Remote ID (direct remote identification in EU law) is a radio signal a drone broadcasts for the whole flight. It carries the operator’s registration number, the drone’s serial number, its position, height, course and speed, and the position of the pilot or the take-off point. Since 1 January 2024, in the European Union it must be broadcast by drones with a C1, C2 or C3 class mark flying in the open category, and by every drone in the specific category.

What exactly a drone broadcasts

Regulation 2019/945 defines direct remote identification as a system that locally broadcasts information about a drone in operation, so that it can be obtained without physical access to the drone. The drone must broadcast it periodically for the whole flight, over an open and documented protocol, so that existing mobile devices within range can receive it.

Under the C1 class requirements (Annex, Part 2 point 12) the signal carries at least:

  1. the operator registration number and its verification code,
  2. the drone’s unique serial number,
  3. a time stamp, the drone’s position and its height above the surface or the take-off point,
  4. its course from true north and its ground speed,
  5. the pilot’s position or, if that is not available, the take-off point,
  6. an indication of emergency status.

The operator number has 16 characters, and the first three are the country code, so a Polish number starts with POL. Operators also display the same number on their drones (Article 14(8) of Regulation 2019/947).

Which drones must broadcast Remote ID

Drone Remote ID Legal basis
Class C0 (under 250 g) not required not in the C0 requirements
Class C1 required 2019/945, Annex Part 2 point 12
Class C2 required 2019/945, Annex Part 3 point 14
Class C3 required, unless tethered 2019/945, Annex Part 4 point 9
Class C4 not required not in the C4 requirements
Any drone in the specific category, including C5 and C6 required 2019/947, UAS.SPEC.050(1)(l)
Older drone without a class mark (sold before 1 January 2024) not required in the open category 2019/947, Article 20

In the open category the duty therefore applies to class-marked drones. Before each flight the pilot checks that Remote ID is active and up to date (UAS.OPEN.060(1)(d)). Older drones without a class mark may keep flying in subcategory A1 if they weigh under 250 g, or in A3 if they weigh under 25 kg, and the rules do not require them to broadcast Remote ID. That is our reading of Article 20 and the UAS.OPEN rules, where the requirement appears only for class-marked drones.

A drone without built-in Remote ID can be fitted with an add-on module (Annex, Part 6). It broadcasts the same data except emergency status, and gives its own serial number instead of the drone’s.

Direct and network Remote ID

Direct Remote ID is broadcast by radio, on the spot. The receiver has to be within range but needs no internet connection. Network Remote ID sends the data over the internet to an outside service. The C1 to C3 requirements treat it as an extra: they describe how it must work but don’t make it compulsory. Only direct Remote ID is mandatory.

What Remote ID won’t tell you

It won’t tell you who was actually flying. The operator number lets the registry show who owns the drone, not who held the controller at that moment.

It won’t show drones that don’t broadcast. C0 drones, older drones without a class mark, home-built drones and most FPV drones fly without Remote ID, and so do drones whose transmitter has been switched off.

It also works only within broadcast range, which depends on the drone’s transmitter, the receiver and the buildings around them.

That is why detection through Remote ID is a first step, not a full counter-drone system. Drones that don’t broadcast are detected by radar or by radio-frequency analysis.

Who can receive Remote ID

Anyone. The rules require the signal to be receivable by ordinary mobile devices, and EASA says plainly that every citizen can read it in a smartphone app.

A phone app shows a drone that is flying right now, if you happen to be looking at it. HARQ sensors receive the same signal around the clock: they alert your security team, show the drone and the pilot on a map and record every flight. You can later export the record and attach it to a police report.

Sources